Troxler 5850v2 - Page 79

Model 5850v2 Appendix A–3
A. TROUBLESHOOTING
Gyration data does not print automatically following a
compaction cycle
1
1
.
.
Ensure that the Auto Output feature is enabled (see page 3–11).
2
2
.
.
Ensure that the proper output device is selected (see page 3–12).
Gyration data does not print or download properly
1
1
.
.
Ensure that the Auto Output feature is enabled (see page 3–11).
2
2
.
.
If printing or downloading data to a USB device, ensure that the
device is compatible with the compactor. A list of compatible
USB memory devices and printers is available on the 5850v2
product page at www.troxlerlabs.com/.
General calibration problems
1
1
.
.
Check all cable connections.
2
2
.
.
For the height calibration, ensure that the puck, specimen
papers, and height standard assembly are located properly on
the lower carriage plate.
3
3
.
.
For the pressure calibration, ensure that the pucks and the load
cell are located properly on the lower carriage plate.
4
4
.
.
Repeat the calibration once. If you still have problems with the
calibration, call your Troxler representative.
Compactor displays: Pressure Calibration
Communication Error
1
1
.
.
Check all connections between the compactor and the external
load cell.
2
2
.
.
Check the power connection to the load cell.
All other compactor error messages
Record the error message, and then contact Troxler at
1.877.TROXLER (1.877.876.9537) for further information.