XRS2 and SRS2 EID Stick Reader
Issue 5, 03/2018
19
LCD handling and storage precautions
1 Do not subject the LCD panel to physical shock as the glass may break and injuries may occur.
2 If the glass breaks, do not touch it with bare hands. Fragments of broken glass may cause injuries.
3 Seek adequate first aid in the event of an injury.
4 If the LCD panel glass breaks, do not let liquid crystal come into contact with mouth.
5 If liquid crystal comes into contact with your skin, wash thoroughly with soap and water.
6 If liquid crystal gets into eyes, rinse with clean water for at least 15 minutes and consult a doctor.
7 If scrapping this product, follow disposal standards of industrial waste that is legally valid in the community,
country or territory where you reside.
8 Do not connect or disconnect the LCD while powered.
9 Do not attempt to disassemble or modify the LCD as it is a precision component.
10 Avoid the display coming into contact with other circuitry when powered.
Using flat flexible circuit (FFC) cables and connectors
The display and the keypad use FFCs (flat flexible circuits) to connect to the main PCA. If you have to replace the
display or keypad or re-insert the FFC, please ensure that you follow these guidelines to avoid damaging the FFC
or the connectors on the PCA.
Do not force the FFC tail into the FFC connector.
The track on the FFC has a pitch of only 0.5 mm (1/50“) and is only on one side of the strip. It is therefore
critical that it is inserted straight and in the correct orientation.
To Next Page
Loading...
Need help?
General