TRUE ICE truemfg.com
TEC_TM_171 | REV. G | EN
P#224534
02/28/2024 Page 10 of 72
Important Safety Information (cont.)
WARNING!
High Voltage Inside!
Open circuit voltage and voltage to ground 600v.
Risk of electric shock, burn, or fire!
• It is the appliance owner's responsibility to ensure the electrical connection meets all applicable building codes. Failure
to meet these code requirements can result in appliance damage, fire, electric shock or burns, serious personal injury, or
death.
• All field wiring must conform to all applicable codes of the authority having jurisdiction. It is the responsibility of the end
user to provide the disconnect means to satisfy local codes
• Before connecting your Ice machine to the power supply, verify the supply voltage and circuit rating match the nameplate
and rating labels. Correct improper supply voltage or circuit size immediately. See "Label Locations" (pg. 15).
• Before connecting your ice machine to the power supply, verify the power supply is correctly grounded. If the power
supply is not grounded, correct immediately. TRUE recommends hiring a qualified electrician to inspect your electrical
circuit to ensure they are properly grounded.
• For personal safety, your ice machine must be properly grounded.
• The ice machine should receive power from its own individual dedicated electrical circuit. This provides the best
performance and prevents overloading the power supply.
• Toggling the rocker switch does not remove power from all components. Unplug the ice machine or turn off the power
supply before installation or servicing.
• This equipment must be positioned so that the plug is accessible unless other means for disconnection from the power
supply (e.g., circuit breaker or disconnect switch) are provided
• Check all wire connections, including factory terminals, before operation. Connections can become loose during shipment
and installation.
• DO NOT clean appliance with a pressure washer or hose. DO NOT immerse power cord in water.
NOTICE!
TRUE will not warranty the following:
• Compressor failures due to improper incoming voltage.
For more details, see TRUE's full warranty statement. Find a copy of the wiring diagram with our Serial Number
Lookup at truemfg.com/support/serial-number-lookup.
Electrical Safety Warnings
To Next Page
Loading...
Need help?
General
