TRUE ICE
TEC_TM_171 | REV. G | EN 02/28/2024 Page 15 of 72
truemfg.com
About Your Ice Machine & Installation Requirements (cont.)
Right-Side Breathing Left-Side Breathing
or
Fig. 2. Air flows into the front/sides and out the rear.
• Ice Machine is not suitable for outdoor use.
• Before connecting your ice machine to the power supply, verify the incoming voltage (±5%) and the amps match the operation
ratings on the appliance's nameplate and rating labels. Correct improper incoming voltage or amps immediately. See "Label
Locations" (pg. 15) and "Cord Specifications" (pg. 26).
• Before connecting your ice machine to the power supply, verify the power supply is correctly grounded. If the power supply is not
grounded, correct immediately.
• Ensure the installation location will provide adequate clearances and sufficient airflow for the ice machine. See "Ice Machine
Specifications" (pg. 14).
• Read and follow all warnings and maintenance instructions. Failure to do so may result in damage and void the warranty on your
appliance.
• Do not locate the equipment near any heat source, direct sunlight, areas with high ambient conditions or without proper clearance
for ventilation. Placing equipment in these locations will result in reduced capacities, high system pressures and may cause
equipment failure.
• This ice machine will pull air in from the front/sides and exhaust air out the back. See fig. 2. This ice machine will also reverse fan
motor periodically to remove dirt from the condenser coil.
Label Locations
The nameplate and rating labels contain important information such as your model name, serial number, and refrigerant type.
• Locate the nameplate label on the lower left inside wall of the ice machine.
• Locate the rating label on the rear panel.
To Next Page
Loading...
Need help?
General
