TRUE ICE
TEC_TM_171 | REV. G | EN 02/28/2024 Page 55 of 72
truemfg.com
WARNING!
Replace component parts with original equipment manufacturer (OEM) components to minimize the risk of possible ignition
due to incorrect parts or improper service.
Moving parts hazard!
Moving parts can cut. Keep hands clear when panels are removed.
Maintenance & Servicing (cont.)
NOTICE!
The appliance owner is responsible for maintaining the ice machine as described in this document. Routine care
and maintenance procedures are not covered by TRUE's warranty.
Do not use power cleaning equipment, steel wool, scrapers or wire brushes on stainless steel or painted surfaces.
NOTICE!
If the ice machine will not be used for 2-3 days under normal conditions turn the unit off .
Removal from Service & Winterization
If storing your ice machine for an extended time or in sub-freezing temperatures, winterize the appliance.
1. Clean and sanitize the ice machine. See "Descaling and Sanitizing Procedure" (pg. 60).
2. Turn off the water supply.
3. Disconnect and drain the water supply line at the rear of the ice machine and drain the sump.
4. In the Home Screen, press MANUAL . Then, press FILL . Wait for 3 seconds then blow compressed air in the water supply
fitting in the rear of the ice machine to remove all water.
5. When complete, press cancel to exit the manual drain operation.
6. In the Home Screen, press MANUAL. Then, press DRAIN . Wait for 3 seconds then blow compressed air in the drain fitting in the
rear of the ice machine to remove all water.
7. When complete, press cancel to exit the manual drain operation.
8. Disconnect electrical power at the main disconnect/circuit breaker.
9. Fill spray bottle with sanitizer and spray all interior food zone surfaces.
10. Reinstall all panels.
WARNING!
DO NOT rinse the parts with clean water after sanitizing.
Let them air dry.
To Next Page
Loading...
Need help?
General
