TRUE ICE truemfg.com
TEC_TM_171 | REV. G | EN
P#224534
02/28/2024 Page 54 of 72
Maintenance & Servicing
Maintenance & Servicing
WARNING!
Only qualified technicians should install and service the ice machine. For assistance finding a qualified technician, please visit
our Service Company Locator at
truemfg.com/support/service-locator/. TRUE is solely the appliance manufacturer and is
not responsible for installation, service, and routine maintenance.
Turn off and lockout all utilities (gas, electric, water) according to approved practices during maintenance or servicing.
The appliance owner is responsible for performing a Personal Protective Equipment (PPE) Hazard Assessment and ensuring
adequate protection during maintenance and cleaning procedures.
Use appropriate tools, safety equipment, and PPE during installation and servicing.
Sharp Edges!
• Take care when moving, installing, cleaning, servicing, and maintaining the ice machine to avoid cuts. Be sure to take care
when reaching under the ice machine or handling metal components.
• Stay clear of pinch point areas, such as the space between appliance doors and surrounding cabinetry. Take care closing
doors with children nearby.
Risk of electric shock or burn!
• Toggle the rocker switch does not remove power from all components. Unplug the ice machine or turn off the power
supply before installation or servicing.
• DO NOT clean your ice machine with a pressure washer or hose.
Tip over hazard!
Ice machine may pose a tipping hazard when uncrating, installing, or moving the appliance. Take appropriate safety
precautions. Use of tip over restraints may only reduce (not eliminate) the tipping hazard. Never allow children to climb or
hang on drawers, doors, or shelves.
Two or more people are required to move this equipment to prevent tipping.
Crush or cut hazard!
Keep clear of moving components. Components can move without warning unless power is disconnected.
Optical radiation hazard! UV light!
Invisible laser radiation. Do not look directly at light. Always disconnect power before servicing the lamp.
To Next Page
Loading...
Need help?
General
