TRUE ICE
TEC_TM_171 | REV. G | EN 02/28/2024 Page 25 of 72
truemfg.com
About Your Ice Machine & Installation Requirements (cont.)
Fig. 2. Rocker switch location. Rocker switch disconnects power from the control board
and front display; it DOES NOT disconnect power from the entire unit.
Fig. 4. Junction box electrical label.
Fig. 3. Make the electrical connections inside the ice machine's junction box. Be sure to use strain reliefs. Always use the green grounding screw when making
electrical connections.
To Next Page
Loading...
