TRUE ICE truemfg.com
TEC_TM_171 | REV. G | EN
P#224534
02/28/2024 Page 66 of 72
Maintenance & Servicing (cont.)
5. When "Would you like the unit to start making ice once
descaling and/or sanitizing is complete?" appears, press
either NO or YES.
6. Wait for the ice machine to run through the PRE-CLEANING
sequence (FILL, PUMP, DRAIN, and HARVEST). If there is enough
water in the sump at the start of CLEAN, it will go through a
DRAIN sequence before FILL.
The compressor will start during the HARVEST sequence to
ensure there is no ice on the evaporator and will shut off
before the cleaning sequence continues.
7. When ADD CLEANER appears, open the water curtain and
pour in 10 oz (296 mL) of TRUE ice machine descaler between
the evaporator and the damper.
8. After adding the descaler, press OK. The display will then show
the sequence status.
NOTICE ›
The sequence will not proceed from this point
unless OK is pressed after adding the cleaner. When the
procedure is finished, the ice machine will automatically enter
the sanitizing sequence.
9. Let the ice machine finish the descaling sequence. When ADD
SANITIZER appears, open the water curtain and pour in 1 oz
(14.8 mL) chlorine bleach (5.25% sodium hypochlorite)
between the evaporator and the damper.
10. After adding chlorine bleach (5.25% sodium hypochlorite),
press OK. The display will then show the sequence status.
NOTICE ›
The sequence will not proceed from this point
unless OK is pressed after adding chlorine bleach (5.25%
sodium hypochlorite).
11. Let the ice machine finish the sanitizing sequence. Once the
sanitizing sequence is complete, the ice machine will either go
into STANDBY mode or return to MAKE ICE mode based on the
choice made in step 5.
To Next Page
Loading...
Need help?
General
