TSC ME240 - LED Indicators; Setting up the Printer

13
2.3.2 LED Indicators
LED
Status
Indication
POWER
Off
The printer power is turned off
On
The printer power is turned on
ON-LINE
On
Printer is ready
Blinking
Pause
Downloading data into printer
ERROR
Off
Printer is ready
On
“Carriage open”, “Cutter error” or “Clearing data”
Blinking
“No paper”, “Paper jam” or “No ribbon”
2.4 Setting up the Printer
1. Place the printer on a flat, secure surface.
2. Make sure the power switch is off.
3. Connect the printer to the computer with the provided USB cable.
4. Plug the power cord into the AC power cord socket at the rear of the printer, and then plug
the power cord into a properly grounded power outlet.
Note:
Please switch OFF printer power switch prior to plug in the power cord to printer power jack.