TSC ME240 User Manual

32
This option is used to set the origin of printer coordinate system horizontally and vertically.
Press the button to move the cursor from left digit to right digit, and press the
button to set the value from “0” to “9”. Press the button to set the value
into printer. Press key to cancel the setting and return to the previous menu.
The default value is 000.
Note: If printing from enclosed software/driver, the software/driver will send out the
REFERENCE command, which will overwrite the setting set from the front
panel.
3.1.1-1.8 Code Page:
Use this option to set the code page of international character set. For more information
about code page, please to refer the programming manual.
When enter the code page list, the code page in the right side of “>” icon is the printer
current setting.
Press the and to select the code page, and press the button
to enable the setting. Press key to cancel the setting and return to the previous
menu.
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
7-bit
8-bit
code page name
International
Character Set
code page number
International
Character Set
USA
USA
437
United States
BRI
British
850
Multilingual
GER
German
852
Slavic
FRE
French
860
Portuguese
DAN
Danish
863
Canadian/French
ITA
Italian
865
Nordic
SPA
Spanish
Print Setup 9/12
Shift Y
Reference X
>
Reference Y
Reference Y
000
Print Setup 10/12
Reference X
Reference Y
>
Code Page
Code Page 11/41
>
850
852
860

TSC ME240 Specifications

General

Resolution	203 dpi / 300 dpi
Operating Temperature	5°C to 40°C (41°F to 104°F)
Print Method	Thermal Transfer & Direct Thermal
Interface	USB
Power Supply	AC 100-240V, 50/60Hz
Humidity	20% to 85% RH (non-condensing)