A. Gap Mode
Press the and buttons to scroll the cursor to the media type and press the
button to enter the sensor calibration mode.
Note: If printing from enclosed software/driver, the software/driver will send out the
GAP or BLINE command, which will overwrite the sensor type setting set from
the front panel.
A-1 Automatic
When enter the [Automatic] option, you will see following message, and printer will
feed 2 to 3 gap labels to calibrate the sensor sensitivity automatically. When
calibration is completed, the LCD screen will return to the previous menu.
A-2 Manual
In case “Automatic” sensor calibration cannot apply to the media, please use
“Manual” function to calibrate the gap sensor manually.
When enter [Manual] option, you will see following message. Please complete those
steps：
1. Press the button to move
the cursor from left digit to right digit,
and press the button to set
the value from “0” to “9” and the “dot/
mm/ inch”. Press the
button to set the paper length into the
printer.
To Next Page
Loading...
