TSC ME240 User Manual

71
The default IP address is obtained by DHCP. To change the setting to static IP address,
click “Static IP” radio button then enter the IP address, subnet mask and gateway. Click “Set
IP” to take effect the settings.
Users can also change the “Printer Name” by another model name in this fields then click
“Set Printer Name” to take effect this change.
Note: After clicking the “Set Printer Name” or “Set IP” button, printer will reset to take
effect the settings.
8. Click “Exit” button to exit the Ethernet interface setup and go back to Diagnostic Tool main
screen.
Factory Default button
This function will reset the IP, subnet mask, gateway parameters obtained by DHCP and
reset the printer name.
Web setup button
Except to use the Diagnostic Utility to setup the printer, you can also explore and configure
the printer settings and status or update the firmware with the IE or Firefox web browser.
This feature provides a user friendly setup interface and the capability to manage the printer
remotely over a network.

TSC ME240 Specifications

General

Resolution	203 dpi / 300 dpi
Operating Temperature	5°C to 40°C (41°F to 104°F)
Print Method	Thermal Transfer & Direct Thermal
Interface	USB
Power Supply	AC 100-240V, 50/60Hz
Humidity	20% to 85% RH (non-condensing)