After clicking Set button, it'll pop-up the window tip
as below shown.
IP address will be shown in the “IP address” field .
IP address should be shown within about 5~15
seconds after printer turn on. If not, please refer to
steps below to initialize the printer Wi-Fi module
settings then to setup it again.
Remove the cable between the computer and the
printer.
Go to main page, click Add Printer to add the
printer via Network.
Select the printer and enter the setting page by
double clicking the printer.
Click the Print Test Page button to print the test
page via Wi-Fi interface.
To Next Page
Loading...
Need help?
General
