26
TROUBLESHOOTING
Correct wiring or replace
it if damaged.
Replace the door
switch(es).
Troubleshooting:
“Door Open” Message when Door is Closed
Non-Fault Code Troubleshooting
This section provides troubleshooting tips for issues that may occur independently of an oven fault.
NO
YES
YES
Is the wiring from the door switches
to I/O control board (SAGE) OK?
Adjust/tighten the door
(see Appendix for door
assembly detail, page A-4).
Adjust the door switch(es)
to allow the switch(es) to
close (page 38, section “Door
Interlock Switches”). Is the
issue resolved?
NO
NO
Check the door/door
hinge connection. Is
the door loose on the
hinge arms?
To Next Page
Loading...
