turck TBEN-L 8IOL Series - Parameter Data Storage Mode = Read in

Operating
Using the data storage mode
138
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
10.5.2 Parameter ”data storage mode” = read in
n The data set in the device is always the reference data set.
n The synchronization of the parameter sets is unidirectional towards to the master.
n The status of the DS_UPLOAD_FLAG is ignored.
IOLM IOLD
1
Fig.66: Data storage mode = read in – parameter set in the device changed
10.5.3 Parameter ”data storage mode” = overwrite
n The data set in the master is always the reference data set.
n The synchronization of the parameter sets is unidirectional towards to the device.
n The status of the DS_UPLOAD_FLAG is ignored.
IOLM IOLD
1
Fig.67: Data storage mode = overwrite – parameter set in the master changed
10.5.4 Parameter ”data storage mode” = deactivated, clear
n The data set in the master is deleted.
n The synchronization of parameter sets is deactivated.
IOLM IOLD
Fig.68: Data storage mode deactivated – no synchronization