turck TBEN-L 8IOL Series - Mounting; Mounting the device outdoors

V02.00 | 2019/10
19
6 Mounting
The TBEN-L module can be screwed onto a flat mounting plate.
 Attach the module to the mounting surface with two M6 screws. The maximum tighten-
ing torque for the screws is 1.5 Nm.
 Avoid mechanical stresses.
 Optional: Ground the device.
218 [5.58]
M6 (2x)
max. 1.5 Nm
Fig.7: Mounting the device onto a mounting plate
6.1 Mounting the device outdoors
The device is UV-resistant according to DIN EN ISO 4892-2. Direct sunlight can cause material
abrasion and color changes. The mechanical and electrical properties of the device are not af-
fected.
 To avoid material abrasion and color changes: Protect the device from direct sunlight,
e.g. by using protective shields.