MAN205-0195042EN Rev. A Aug. 2011
Page 58 of 137 pages
4.3.6 Display During a Cycle
Display during the Pre-Vacuum Stage
When the cycle passes to the Heat stage the steam enters the system, in place of
‗PUMP TO 25K‘, it will display ‗HEAT TO 160K‘.
When the cycle passes to the Exhaust stage,‘ it will display ‗EXH TO 100K‘.
Display during the Heating Stage
Display during the Sterilization Stage
Display during the Drying Stage
Help:
If at any stage there is a problem, you can turn the system can be OFF at the power
switch. Turn ON the power again while pressing STOP till you hear a long buzz. After
loading, the screen lights with the message below.
The display returns to the ST.BY screen and you can continue.
To Next Page
Loading...