TVS XL Series User Manual

SEAT LOCK*
To access the carrier*, the pillion seat assembly*
need to be removed.
To remove the pillion seat assembly, insert the
control key into the seat lock which is located at the
left side rear end of the vehicle and rotate the key in
clockwise direction. Once the lock is released,
gently take out the seat from its mounting.
To assemble back the seat, locate the seat in its
position and push it towards the front and then
press down.
KNOW YOUR TVS XL 100
TOOL KIT
To assist you in performing certain aspects of
periodic maintenance and emergency repairs, a
tool kit is supplied along with the vehicle and it is
located inside the tool box.
To access the tool kit, open the tool box lid as
explained in the page no. 12.
The tool kit consists of the following :
1. Grip driver x 1
2. Bit (+) (–) x 1
3. 17 x 19 open end spanner x 1
4. Tool bag x 1
-13-
* Not applicable for Comfort models
KNOW YOUR TVS XL 100

TVS XL Series Specifications

General

Displacement	99.7 cc
Maximum Torque	6.5 Nm @ 3500 rpm
Fuel System	Carburetor
Front Brake	Drum
Rear Brake	Drum
Starting Method	Kick Start
Engine Type	Single Cylinder, 4-Stroke
Front Suspension	Telescopic
Rear Suspension	Swing Arm with Hydraulic Shock Absorber
Fuel Tank Capacity	4 liters
Kerb Weight	80 kg
Wheel Type	Spoke
Tyre Type	Tube
Front Tyre Size	2.50 - 16
Rear Tyre Size	2.50 - 16
Seat Height	770 mm
Ground Clearance	150 mm
Transmission	Single Speed Gearless