Ultimaker Original - From YouMagine.com to Cura

C3. From YouMagine.com to Cura
YouMagine.com is an online community for 3D printing.
1. Open your browser and go to
www.youmagine.com
2. 


and ‘Enter’.
3. Choose a design you like.
4. The following page will provide you with a
‘Download’ button where you can get your .stl

5. 
software, this will be explained more fully in the
next
chapter.
Tip: If you’ve made a 3D design yourself, you
can contribute back to the YouMagine commu-
nity!
Now that you are familiar with Cura we continue to explain how you
YouMagine.com and load this into Cura.
NOTE: The screenshots may not look and work
exactly the same because this platform is in
continuous development.
18 