25D3. Use of the controller during printing Use of the Ultimaker controller display
You can start a print by navigating to >Print from SD ->-
end to approximately 210°C. Next it will load the data and start your print.
When a print has been initiated one option in the menu will change. Instead of >prepare ->,
>Tune -> . In the tune-menu you can live tune your printer.
Meaning you can change parameters of the print process, while printing.
your SD-card with Cura (Cura set to Ultimaker Original machine settings). Safetly remove the
navigate to >Print from SD ->
print should start. When you do not use your UltiController it automaticly reverts back to the
>Speed: The speed you are printing in will increase/decrease. Changing the speed can be done
>Nozzle:
>Bed: With Bed you have the option to change the temperature of your heated bed.
>Fan Speed: You can change the speed of your fan from 0-255. But in thehe slicer you can
>Flow:
This can be interesting when you are over or underextruding with the current settings. However,
your slicer. An inaccurate value may result in the same complains.
>Change ilament: -
the UltiController to continiue the print
D3. Use of the controller during printing
To Next Page
Loading...
