Ultimaker Original - Page 24

24Use of the Ultimaker controller display
3. When you have selected >Control -> you will proceed to the next sub-menu where you

4. When there is no card inserted this function will indicate >No Card ->. When you have
selected >Print from SD -> you will access a sub-menu where all the Gcodes on your SD-
card will be visible.
Temperature: 

Motion: Only make changes in the Motion menu if you know what you are doing. More can be
found at our wiki page (http://wiki.ultimaker.com/)
Store memory: Save the settings you have changed in the control menu.
Load memory: If you ever made and saves any changes in the settings, this option allows
you to load them.
Restory failsafe: Restore failsafe will reset your UltiController to its Original settings. All
the settings you previously changed will be deleted.
Firmware version: -
ker Original.