3 – TRANSFER OF PROGRAMMATION DATAS
The programme versions starting from V86 allows to save or restore all the configured and programmed
parameters of the machine with a new magnetic card called « DATA card ». The use of the previous client
and technician cards remain unchanged.
At the opposite, the code 4441 will not launch a « RESET » of the machine, but will be used for
data transfer from the card to the machine.
The code 3331 allowing to put down to zero the coffee counter will have to be activated only with a
DATA card
Operational way:
The machine must be put in position 1, no cycle working, without activated security.
c Insert the data card in the reader of machine
d Push on the touch PRO the display shows
e Make the code corresponding to the operation you need according to the board hereunder
C O D E
4441 4442 4443 3331
OPERATION
To restaure the data
FROM CARD
TO MACHINE
To save the data
FROM MACHINE
TO CARD
To restaure Text
FROM CARD
TO MACHINE
Reset
Coffee counters
DISPLAY
DOWNLOAD PARAMETRES
CONFIRM >>PRO
UPLOAD PARAMETRES
CONFIRM >>PRO
DOWNLOAD TEXT
CONFIRM >>PRO
COUNTERS RESET
CONFIRM >>PRO
ENTER
TOUCH PRO TOUCH PRO TOUCH PRO TOUCH PRO
DISPLAY
DOWNLOAD PARAMETRES
WAIT
UPLOAD PARAMETRES
WAIT
DOWNLOAD TEXT
WAIT
Time Date
CODE > PRO
At the end of the transfer, the display goes back to initial state
E – 5
CODE
Code > XXXX
Time Date
Code >PRO
To Next Page
Loading...
Need help?
General
