73
Programming Your Scanner
Off — the scanner ignores I-calls. The default setting is Off.
Only — the scanner only tracks I-calls and ignores other radio traffic on the
system. Press
F to select.
Note: To set the I-Call to a wildcard receive condition, press [.No] + [0].
[MENU] Program System F
Select a Motorola Type I, II or EDACS Wide/Narrow system F
Edit Sys Option F
Emergency Alert F
Off — the scanner does not alert you to emergency transmissions.
Alert 1 - 9 — the scanner sounds an alert beep to notify you of the emergency
transmission. The default alert is Off. You can choose any of 9 different beep
types. Once you choose an alert tone, next:
Set Level F
Auto — the scanner automatically sets the emergency alert beep to the master
volume level.
Level 1 - 15 — the scanner adjusts the volume you hear to the level you select.
[MENU] Program System F
Select an EDACS Wide/Narrow system F
Edit Sys Option F
EDCS ID Format F
EDACS Talk Group ID’s are commonly provided in one of two formats: AFS and
Decimal. This setting determines how you enter EDACS ID’s and how the scanner
displays them.
AFS Format — the scanner uses AFS format for Talk Group ID’s
Decimal Format — the scanner uses decimal format for Talk Group ID’s
Note: The scanner defaults to AFS (agency, fleet, subfleet) format - the format
used in most EDACS systems.
Setting the Emergency Alert Option ME
Setting the EDACS ID Format E
To Next Page
Loading...
Need help?
General
