75
Programming Your Scanner
[MENU] Program System F
Select a conventional system F
Edit Sys Option F
Adjust P25 Level F
This setting determines some system-specific parameters for digital channels. In
most cases, setting this to Auto provides the best performance. However, you can
also manually set the digital decode threshold. This setting affects all channels in
the current system. See
“Optimizing P25 Performance” on Page 52.
Auto — the scanner automatically adjusts the digital decode threshold to match
the transmission you are hearing when it receives a strong signal and has a high
decode rate.
Manual — lets you manually adjust the digital decode threshold. To manually
adjust the P25 level, select Manual.
Default — sets the digital decode threshold to the default value. Use this setting
to return to the value that usually provides adequate performance. This is handy
as you have manually adjusted the value to a setting that prevents proper
decoding.
Note: This setting has no effect on how these systems are received.
Use this option to enter and edit site information for the current system. See
“Programming Sites” on Page 76 for instructions for each site option. Note that you
must program at least one site for each trunked system in order for your scanner to
scan the system.
Use this option to enter and edit channel groups and channel information. See
“Programming Channel Groups” for instructions for each channel group and
channel option. Note that you must program at least one channel group and one
channel for each conventional system in your scanner. You do not have to enter
channel group information for trunked systems, but doing so makes it easier to
follow specific talk groups.
Adjust the P25 Decode Threshold C
Editing Sites MESL
Editing Channel Groups MECL
To Next Page
Loading...
Need help?
General
