Uniden UBC 245XLT Trunk Tracker II - Scanner Programming

Programming
Before the UBC245XLT can begin conventional
scanning, you must program a frequency into at least
one channel. Repeat this procedure for each channel
you want to program.
1. Select frequencies
from your dealer,
from various sources.
Here’s a list of sample frequencies you should try.
476.425 MHz UHF CB CH1
476.450 MHz UHF CB CH2
476.475 MHz UHF CB CH3
476.500 MHz UHF CB CH4
2. Press .
3. Select a channel.
a. Enter the channel
number.
b. Then press .
12345678910
16