Frequency Find Mode
n
Press the while
a talk group ID is active
and the display will flash
the frequency on which that
talk group is transmitting.
n
Press and hold for
two seconds and the display
will automatically flash the ID
and the frequency alternately
until you set the condition by
pressing the key again.
Direct Entry ID Hold Mode
During Search mode, you can hold on an ID without
entering it into memory.
1. When a talk group is
active, press
to stop the
search mode.
2. Use the keypad to
enter the ID you want.
Channel number
flashes in the display.
3. Press again.
HOLD flashes in the
display.
4. Press to return to
Search mode.
Note: The ID Hold mode works in Scan List mode, and
the steps are the same; however,
SEARCH
doesn’t appear in the display.
43
To Next Page
Loading...
Need help?
General