Clone Mode
YoucanclonethefrequencydataofoneUBC245XLT
scanner to another. After connecting the two scanners,
using the Scanner to Scanner steps (See page 63), make
sure the scanners are turned off. On each scanner, press
and hold
REMOTE
key and turn the radio on. Then release
the key. bc245 will appear on the display.
1. On each scanner,
press or
or until this
screen is displayed on
both scanners. Then
press .
(Clone Mode)
2. Determine the
scanner that has the
frequency data that
you want to transfer.
This one must be set
up as the “First” unit,
and the other must be
set as the “Clone”.
3. On the scanner that
has the desired
frequency data, press
the key until
FirSt appears in
the display.
4. On the scanner that is
the “Clone”, press the
key until ClonE
appears in the
display.
5. Press the key on
both scanners. The
data transfer is started
from the “First” unit to
the “Clone” unit.
72
To Next Page
Loading...
Need help?
General