Uniden UBC 245XLT Trunk Tracker II - Programming with SVC Scan

Programming with SVC Scan
Follow these steps to program frequencies into a channel
during Service scanning:
1. Select a channel you
want to program.
Note: If a frequency is
already stored in the
channel you select it
will be erased when
you save the new
frequency.
2. Press repeatedly
to select Service Scan
mode you want.
3. Press to begin
scanning.
4. When SVC Scan
stops on a frequency
you want, press
.
5. Press to store the
frequency in the
channel you selected.
35
12345678910
12345678910