Scanning
1. After programming
frequencies, simply
press to begin
scanning.
2. The bank indicators selected for scanning appear in
the display, and the bank being currently monitored
flashes. You can deselect banks from active
scanning by pressing their number on your keypad.
The indicator for each deselected bank turns off, and
the bank’s channels are not scanned.
Note: One Bank must always be active. You cannot
deactivate all ten banks at the same time. If you try
to turn all the banks off, the first bank is
automatically selected.
To restore a bank to active scanning, press the
bank’s number on your keypad. The bank’s indicator
will display again.
3. During normal
scanning the scanner
skips unprogrammed
or locked
out channels.
4. When a transmission
is received, the LCD
back light comes on
for five seconds and
the scanner stops on
that channel, provided
that you have
selected the Auto
Light feature. When
the transmission
ends, scanning
resumes
automatically.
20
12345678910
1 3 4 5 9 102 6 7 8
CHANNELS
Frequency not
entered
Frequency
Locked Out
(L/O)
SCAN
12345678910
To Next Page
Loading...
Need help?
General