Uniden UBC 245XLT Trunk Tracker II - Page 45

4. Use the keypad to
enter a frequency for
the trunked system.
For example, enter
856.2625 (Type 1), or
enter a frequency of
the system you’re
going to track.
Note: To clear a mistake while entering a
frequency, press twice, and start over.
Then press .
If the frequency is out
of the range of the
system chosen in this
step, an error
message displays.
Press and go back
to Step 3.
5. Press either or
to select the
next channel in
the bank.
6. Repeat steps 4 and 5
until all frequencies
have been entered.
7. Press to begin
searching the bank
you’ve programmed.
Then select the
programmed bank
using the keypad.
41
12345678910
BANK
TRUNK
SCAN