SmartScanner software. Run this program and it should
automatically set the port setting for you (although you
can override the settings). Make sure that you have a
phone line plugged into the modem jack on the back of
your PC and your scanner is connected to the serial port
of the PC using the supplied cable.
To use the Remote (PC Control) mode, you must
purchase third party software and use as directed. Make
sure that your scanner is connected to the serial port of
the PC using the supplied cable.
Scanner to External Modem
Plug the smaller end of the supplied Remote interface
cable into the remote port which is on the right side of
the scanner. Plug the other end of the cable (DB-9 serial
connector) into the external modem. You may need a
DB-9 to DB-25 null modem adapter, available at most
computer stores. Of course, make sure your external
modem is turned on. Make sure that you have a phone
line plugged into the modem jack on the back.
Scanner to Scanner
Plug the smaller end of each of the supplied Remote
interface cables into the remote ports which are on the
right sides of each of the two scanners.
Plug the other ends of the cables (DB-9 serial connector)
together using a DB-9 to DB-9 null modem adapter,
available at most computer stores.
To Next Page
Loading...
Need help?
General