1. Orientate the joints according to the alignment marks and gently push the two joints
together.
(In the below drawing the alignment marks are indicated with red)
2. Insert and tighten the countersunk hex screws according to below example and with
correct torque.
Example: 1, 2, 3
3. Insert and cross tighten the hex screws according to below example and with correct
torque.
Example: 1A, 1B, 2A, 2B etc.
UR3 22 Service Manual
5.Service and Replacement of Parts
Copyright © 2009–2021 by UniversalRobotsA/S. All rights reserved.
To Next Page
Loading...
