24
A1 USER MANUAL
3.1.3.1 Buzzer
When delivered with factory settings the
A1 buzzer is active. You can set the A1 to
a stealth mode in the Buzzer submenu
which deactivates all sounds. However,
switching off all alarm sounds requires
the safety code 313 to prevent accidental
deactivation.
WARNING
Setting the “BUZZER OFF” will disable all
audible dive mode alarms and warnings. This
could potentially be dangerous.
3.1.3.2 Button beeps
In this submenu the general button
feedback beeps can be enabled or disabled
by pressing the +/UP or -/DOWN button
followed by SEL/ESC to save the setting.
3.1.3.3 Dive warnings
In this submenu the warnings in dive mode
can be enabled or disabled by pressing the
+/UP or -/DOWN button followed by SEL/
ESC to save the setting.
F
NOTE: Dive alarms are still active
even if you switch the dive warnings
off. Dive alarms are deactivated only
when the buzzer is switched off as
described in chapter 3.1.3.1 Buzzer.
3.1.4 Checking the battery status
When the menu Battery is selected, the A1
shows the last measured battery level.
If you press the SEL/ESC button while in
this menu, a new measurement will be
made. This might take a few seconds; the
A1 will display a “please wait” message
until the revised battery status is available.
To Next Page
Loading...
Need help?
General
