39
English
A1 USER MANUAL
4.1.2.2.2 Classic version
Timer
Average depth
Maximum depth
reached during the
current dive
Current time of the
day
F
NOTE: In GAUGE and SCUBA mode
when the timer is displayed, it can be
stopped by a press-and-hold of the
+/UP button. A repeated press-and-
hold of the +/UP button will restart the
timer. When the timer is stopped, it
can be reset to zero by pressing-and-
holding the -/DOWN button.
4.1.2.3 APNEA mode
If the APNEA mode is triggered manually by
a press-and-hold of the -/DOWN button,
the surface interval starts counting in the
middle of the display without a previous
dive information (depth is --- at top row and
repetitive dive count is 0 at bottom row) as
in the screen below.
However, after an immersion the surface
screen shows the last max depth, surface
interval, water temperature and amount of
repetitive dives during the APNEA session.
By pressing the +/UP button the total time
of this APNEA dive session is shown.
A further press of the +/UP button will
alternatively show the last dive depth and
duration in the middle part of the screen.
During the Apnea dive these two screens
show the current dive depth and duration
and they can be scrolled through by
pressing the +/UP or -/DOWN buttons.
To Next Page
Loading...
Need help?
General
