Uwatec Aladin A1 User Manual

56
A1 USER MANUAL
5.2.6 Updating your A1
In order to update the operating software
on your A1 dive computer, you need to
download the latest software package for
your A1 from the SCUBAPRO website and
store the .swu le locally.
To perform the software update, select the
menu Firmware upload from LogTRAK.
A le selecting pop-up window will appear.
Select the location where you have stored
the .swu le
F
NOTE: A1 will check the battery status
before the update process. If the
battery level is too low, the software
update cannot be started. In order to
update your A1, the battery must be
replaced rst.
Once the Bluetooth connection was
established and the new software version
has been selected, the transfer will start.
The A1 shows the transfer status on the
display with a progress bar.
After successful software download the A1
starts the reprogramming automatically.
Once the new software has been
programmed, the A1 will complete a few
internal checks and perform a reboot.
After a successful update the A1 will
display the message “Software OK”. This
message can be cleared by a short press
of the SEL/ESC button. After this your A1 is
again ready for normal use.
F
NOTE: If the A1 detects any problem
during the transfer, programming
or software checks, an error
message will appear on the display.
In case of an error, switch off
other Bluetooth or WLAN devices
from nearby and bring your A1
closer to the transmitting device.
In case of reoccurring error, check the
SCUBAPRO website or contact your
local SCUBAPRO service center.
You can check the current software version
of your A1 in the menu Settings -> User ->
Service. For checking the last service date
press the +/UP button and the following
screen will be displayed:

Uwatec Aladin A1 Specifications

General

Brand	Uwatec
Model	Aladin A1
Category	Watch
Language	English