36
A1 USER MANUAL
4.1.1 Dive ready mode
A press-and-hold of the -/DOWN button
in the main time and date display will give
you access to the dive ready mode which
shows you your current dive settings.
Information like dive mode, MB- level,
water type selection, MOD and gas oxygen
content will be displayed as follows:
After a dive there are further displays which
can be shown by pressing the +/UP button.
These displays can identify for example the
no-dive time (10h), no-y time (2h), surface
interval (0:06), repetitive dive number (1)
and current & prohibited altitude classes
(0 & 3).
By a further press of the -/DOWN button
the no-dive time (10h), no-y time (2h), and
remaining desaturation time (13:50) will be
shown.
4.1.2 Display conguration during
the dive
Throughout the dive, the A1 displays
depth and dive time always at the top
of the screen. Gas mix and the water
temperature are shown at the bottom
row. The information in the middle of the
screen changes and it is also selectable by
pressing the +/UP or -/DOWN buttons.
4.1.2.1 SCUBA mode display
selection
In SCUBA mode you can choose from
two display versions while diving: Light or
Classic. The following screens illustrate
the information in the middle of the screen
which can be selected as shown in the
sections below.
F
NOTE: The default information in the
middle of the screen at the beginning
of the dive is the No-Stop Time. If
you select another information in
the middle of the screen, there is no
timeout to the default except when
decompression limit is reached.
Decompression time and depth
are appearing in the middle of the
screen after 3 minutes from any other
selected screen.
To Next Page
Loading...
Need help?
General
