Vacon 100 INDUSTRIAL - 3. Modbus Technical Data; 3.1 Modbus RTU Protocol; 3.2 Modbus TCP Protocol

10.4 References 222
10.4.1 Frequency reference 222
10.4.2 Torque reference 223
10.4.3 Torque control in Open loop control 226
10.4.4 Torque control in Advanced sensorless control 226
10.4.5 Preset frequencies 226
10.4.6 Motor potentiometer parameters 230
10.4.7 Joystick parameters 232
10.4.8 Jogging parameters 233
10.5 Ramps and brakes setup 235
10.5.1 Ramp 1 235
10.5.2 Ramp 2 236
10.5.3 Start magnetising 237
10.5.4 DC brake 238
10.5.5 Flux braking 238
10.6 I/O configuration 238
10.6.1 Programming of digital and analogue inputs 238
10.6.2 Default functions of programmable inputs 249
10.6.3 Digital inputs 249
10.6.4 Analogue inputs 255
10.6.5 Digital outputs 260
10.6.6 Analogue outputs 264
10.7 Fieldbus data map 268
10.8 Prohibit frequencies 269
10.9 Supervisions 271
10.10 Protections 271
10.10.1 General 271
10.10.2 Motor thermal protections 273
10.10.3 Motor stall protection 277
10.10.4 Underload protection 279
10.10.5 Quick stop 281
10.10.6 Temperature input fault 282
10.10.7 AI low protection 284
10.10.8 User-defined fault 1 285
10.10.9 User-defined fault 2 285
10.11 Automatic reset 285
10.12 Application settings 287
10.13 Timer functions 288
VACON · 10 TABLE OF CONTENTS
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/