Vacon 100 INDUSTRIAL - Application Settings

P3.10.7 AUTORESET: OVERVOLTAGE (ID 721)
Use this parameter to enable the automatic reset after an overvoltage fault.
P3.10.8 AUTORESET: OVERCURRENT (ID 722)
Use this parameter to enable the automatic reset after an overcurrent fault.
P3.10.9 AUTORESET: AI LOW (ID 723)
Use this parameter to enable the automatic reset after a fault caused by low AI signal.
P3.10.10 AUTORESET: UNIT OVERTEMPERATURE (ID 724)
Use this parameter to enable the automatic reset after a fault caused by unit
overtemperature.
P3.10.11 AUTORESET: MOTOR OVERTEMPERATURE (ID 725)
Use this parameter to enable the automatic reset after a fault caused by motor
overtemperature.
P3.10.12 AUTORESET: EXTERNAL FAULT (ID 726)
Use this parameter to enable the automatic reset after an external fault.
P3.10.13 AUTORESET: UNDERLOAD FAULT (ID 738)
Use this parameter to enable the automatic reset after an underload fault.
P3.10.14 AUTORESET: PID SUPERVISION FAULT (ID 776)
Use this parameter to enable the automatic reset after a PID supervision fault.
P3.10.15 AUTORESET: EXT PID SUPERVISION FAULT (ID 777)
Use this parameter to enable the automatic reset after an external PID supervision fault.
10.12 APPLICATION SETTINGS
P3.11.1 PASSWORD (ID 1806)
Use this parameter to set the administrator password.
P3.11.2 C/F SELECTION (ID 1197)
Use this parameter to set the temperature measuring unit.
The system shows all the temperature-related parameters and monitoring values in the set
unit.
P3.11.3 KW/HP SELECTION (ID 1198)
Use this parameter to set the power measuring unit.
PARAMETER DESCRIPTIONS VACON · 287
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
10