Vacon 100 INDUSTRIAL - Joystick Parameters

10.4.7 JOYSTICK PARAMETERS
Use the joystick parameters when you control the frequency reference or the torque
reference of the motor with a joystick. To control the motor with a joystick, connect the
joystick signal to an analogue input and set the joystick parameters.
P3.3.5.1 JOYSTICK SIGNAL SELECTION (ID 451)
Use this parameter to set the analogue input signal that controls the Joystick function.
Use the Joystick function to control the frequency reference of the drive or the torque
reference.
P3.3.5.2 JOYSTICK DEAD ZONE (ID 384)
Use this parameter to set the joystick dead zone.
To ignore the small values of the reference around 0, set this value to be bigger than 0. When
the analogue input signal is 0 ± the value of this parameter, the joystick reference is set to 0.
-
C
B
D
A
E
-10 V +10 V
-100% +100%
-10%
+10%
Fig. 38: The Joystick function
A. AI joystick dead zone = 10 %
B. Reference
C. MaxFreq
D. Analogue input
E. MaxFreq
VACON · 232 PARAMETER DESCRIPTIONS
10
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/