Vacon 100 INDUSTRIAL - Editing the Values

D. The current location in the menu
E. The indicators of the control place
F. The indicators of the rotation direction
3.3.1 EDITING THE VALUES
CHANGING THE TEXT VALUE OF A PARAMETER
Set the value of a parameter with this procedure.
1 Find the parameter with the arrow buttons.
READY
FAULT
ALARM
STOP
RUN
BUS
KEYPAD
I/O
REV
FWD
2 To go to the Edit mode, push the OK button.
READY
FAULT
ALARM
STOP
RUN
BUS
KEYPAD
I/O
REV
FWD
3 To set a new value, push the arrow buttons Up and
Down.
READY
FAULT
ALARM
STOP
RUN
KEYPAD
I/O
REV
FWD
BUS
4 Accept the change with the OK button. To ignore
the change, go back to the level where you were
before with the Back/Reset button.
EDITING THE NUMERICAL VALUES
1 Find the parameter with the arrow buttons.
2 Go to the Edit mode.
VACON · 78 USER INTERFACES
3
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/