Vacon 100 INDUSTRIAL - User-Defined Fault 1; Automatic Reset

Selection
number
Selection name Description
0 No Action AI Low Protection is not used.
1 Alarm
2 Alarm, preset frequency
The frequency reference is set as in P3.9.1.13 Preset Alarm
Frequency.
3 Alarm, previous frequency The last valid frequency is kept as frequency reference.
4 Fault The drive stops as is set in P3.2.5 Stop Mode.
5 Fault, coasting The drive stops by coasting.
10.10.8 USER-DEFINED FAULT 1
P3.9.9.1 USER DEFINED FAULT 1 (ID 15523)
Use this parameter to set the digital input signal that activates User Defined Fault 1 (Fault ID
1114).
P3.9.9.2 RESPONSE TO USER DEFINED FAULT 1 (ID 15525)
Use this parameter to select the response of the drive to User Defined Fault 1 (Fault ID
1114).
10.10.9 USER-DEFINED FAULT 2
P3.9.10.1 USER DEFINED FAULT 2 (ID 15524)
Use this parameter to set the digital input signal that activates User Defined Fault 2 (Fault ID
1115).
P3.9.10.2 RESPONSE TO USER DEFINED FAULT 2 (ID 15526)
Use this parameter to select the response of the drive to User Defined Fault 2 (Fault ID
1115).
10.11 AUTOMATIC RESET
P3.10.1 AUTOMATIC RESET (ID 731)
Use this parameter to enable the Automatic reset function.
To select the faults that are reset automatically, enter the value 0 or 1 to parameters from
P3.10.6 to P3.10.13.
NOTE!
The automatic reset function is available only for some fault types.
PARAMETER DESCRIPTIONS VACON · 285
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
10