Table 59: Digital output settings on standard I/O board
Index Parameter Min Max Unit Default ID Description
P3.5.3.2.1 RO1 Function 0 62 Varies 11001
46 = Block Out.3
47 = Block Out.4
48 = Block Out.5
49 = Block Out.6
50 = Block Out.7
51 = Block Out.8
52 = Block Out.9
53 = Block Out.10
54 = Jockey pump con-
trol
55 = Priming pump
control
56 = Auto-cleaning
active
57 = Motor Switch
Open
58 = TEST (Always
Closed)
59 = Motor preheat
active
60 = AHF Cap Discon-
nect
61 = AHF Cap Discon-
nect Inv
62 = Run Indication
P3.5.3.2.2
RO1 ON Delay 0.00 320.00 s 0.00 11002
P3.5.3.2.3 RO1 OFF Delay 0.00 320.00 s 0.00 11003
P3.5.3.2.4 RO2 Function 0 56 Varies 11004 See P3.5.3.2.1.
P3.5.3.2.5 RO2 ON Delay 0.00 320.00 s 0.00 11005 See P3.5.3.2.2.
P3.5.3.2.6 RO2 OFF Delay 0.00 320.00 s 0.00 11006 See P3.5.3.2.3.
P3.5.3.2.7 RO3 Function 0 56 Varies 11007
See P3.5.3.2.1. Not
visible if only 2 output
relays are installed.
* = The selection of the application with parameter P1.2 Application gives the default value.
See the default values in Chapter 12 Appendix 1.
THE DIGITAL OUTPUTS OF THE EXPANDER SLOTS C, D AND E
Shows only the parameters for the outputs on option boards in slots C, D and E. Make the
selections as in RO1 Function (P3.5.3.2.1).
This group or these parameters are not visible if there are no digital outputs in slots C, D or
E.
VACON · 124 PARAMETERS MENU
5
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
To Next Page
Loading...
