Table 126: The output signals through RO1
Selection
number
Selection name Description
44
Block Out.1 The output of the programmable Block 1. See parameter
menu M3.19 Drive customizer.
45
Block Out.2 The output of the programmable Block 2. See parameter
menu M3.19 Drive customizer.
46
Block Out.3 The output of the programmable Block 3. See parameter
menu M3.19 Drive customizer.
47
Block Out.4 The output of the programmable Block 4. See parameter
menu M3.19 Drive customizer.
48
Block Out.5 The output of the programmable Block 5. See parameter
menu M3.19 Drive customizer.
49
Block Out.6 The output of the programmable Block 6. See parameter
menu M3.19 Drive customizer.
50
Block Out.7 The output of the programmable Block 7. See parameter
menu M3.19 Drive customizer.
51
Block Out.8 The output of the programmable Block 8. See parameter
menu M3.19 Drive customizer.
52
Block Out.9 The output of the programmable Block 9. See parameter
menu M3.19 Drive customizer.
53
Block Out.10 The output of the programmable Block 10. See parameter
menu M3.19 Drive customizer.
54 Jockey pump control The control signal for the external jockey pump.
55 Priming pump control The control signal for the external priming pump.
56 Auto-cleaning active The Pump auto-cleaning function is activated.
57
Motor Switch Open The Motor Switch function has detected that the switch
between the drive and the motor is open.
58 TEST (Always Closed)
59 Motor preheat active
60 AHF Capacitor Disconnect
61
AHF Capacitor Disconnect
Inverted
62 Run Indication
P3.5.3.2.2 RO1 ON DELAY (ID 11002)
Use this parameter to set the ON delay for the relay output.
PARAMETER DESCRIPTIONS VACON · 263
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
10
To Next Page
Loading...
