Vacon 100 INDUSTRIAL - Lifting VACON 100 IP00 Drive Modules MR10;MR12 with an Options Module

vacon • 12 Installation
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
Figure 2. Lifting VACON
®
100 IP00 Drive Modules MR10/MR12 without options
3.3.4 Lifting VACON® 100 IP00 Drive Modules MR10/MR12 with an options
module
Figure 3. Lifting VACON
®
100 IP00 Drive Modules MR10/MR12 with options module
1
Remove the drive from the package.
2
Use a lifting device that is sufficiently strong for the weight of the drive.
3
Put the lifting hooks in the holes on the top of the cabinet. The maximum lifting angle
is 60°.
4
Lift the drive into a vertical position.
A
A
15641_00
15642_00
≤60°