vacon • 48 User interfaces
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
5. USER INTERFACES
5.1 Keypad of the drive
The control keypad is the interface between the VACON
®
100 AC drive and the user. With the control
keypad it is possible to control the speed of a motor, to supervise the state of the equipment and to
set the AC drive's parameters.
There are two keypad types you can choose for your user interface:
Keypad with graphical display
and
Text keypad.
5.1.1 Buttons
The button section of the keypad is identical for both keypad types.
Figure 13. Keypad buttons
5.1.2 Display
The keypad display indicates the status of the motor and the drive and any irregularities in motor or
drive functions. On the display, the user sees information about the drive and
his
present
location in
the menu structure and the item displayed.
5.1.3 Navigation on keypad
The data on the control keypad are arranged in menus and submenus. Use the Up and Down arrows
to move between the menus. Enter the group/item by pressing the OK button and
return
to the for-
mer level by pressing the Back/Reset button.
The
Location field indicates your current location. The Status field gives information about the
present status of the drive. See Figure 13.
9086.emf
FUNCT
Scroll menu up
Increase value
Scroll menu down
Decrease value
Move cursor left Move cursor right
Move backward in menu
Exit edit mode
Reset faults with long press
Change control place
Access control page
Change direction
Stop button Start button
Enter active level/item
Confirm selection
To Next Page
Loading...
