Vacon 100 INDUSTRIAL - Favorites; User Levels

User interfaces vacon • 77
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
5.3.7 Favorites
NOTE: This menu is not available in text keypad.
Favorites are typically used to collect a set of parameters or monitoring signals from any of the key-
pad menus. You can add items or parameters to the Favorites folder, see chapter .
To remove an item or a parameter from the Favorites folder, do the following:
5.3.8 User levels
User level parameters are intended to restrict the visibility of parameters and to prevent unautho-
rized and inadvertent parameterization on the keypad.
Table 43. User level parameters
Code Parameter Min Max Unit Default ID Description
P8.1 User level 1 3 1 1194
1 = Normal; All menus visible in
the Main menu
2 = Monitoring; Only Monitor,
Favorites and User Levels menus
are visible in the main menu
3 = Favorites; Only Favorites and
User Levels menus are visible in
the Main menu
P8.2 Access code 0 99999 0 2362
If set to other value than 0 before
switching to monitoring when e.g.
user level Normal is active, the
access code will be asked when
trying to switch back to Normal.
Can therefore be used to prevent
unauthorized
parameterization on the keypad.

Motor Nom Freq
50.00 Hz
Favorites
STOP READY I/O

Help
Motor Nom Freq
STOP READY I/O
Monitor
Rem from favorites
OK OK
9172.emf
STOP READY KeypadALARM

ID:2362 P8.2
User levels
User level
Normal
Access code
00000
STOP READY I/OALARM
00000
Min:0
Max:9
ID:2362 P8.2
Access code
OK
9173.emf