Vacon 100 INDUSTRIAL - Press.loss.comp

Parameters vacon • 173
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
7.2.20 Press.Loss.Comp
Figure 66. Position of pressure sensor
If pressurizing a long pipe with many outlets, the best place for the sensor would probably be half-
way down the pipe (Position 2). However, sensors might, for example, be placed directly after the
pump. This will give the right pressure directly after the pump, but farther down in the pipe the
pressure will drop depending on the flow.
PT PT
9101.emf
Pressure
No flow
W
i
t
h
f
l
o
w
Pipe length
Position 1 Position 2