vacon • 32 Startup
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
Push the OK button unless you want to set all parameter values manually.
If you set Motor Type to Induction Motor, you see the next question. If your selection is PM Motor,
the value of parameter P3.1.1.5 Motor Cos Phi is set to 1.00 and the wizard goes directly to question
18.
6
Run Startup Wizard?
Yes
No
7
Make a selection of an application
(P1.2 Application, ID212)
Standard
Local/Remote
Multi-step speed
PID control
Multi-purpose
Motor potentiometer
8
Set a value for P3.1.2.2 Motor Type
(so that it agrees with the nameplate)
PM motor
Induction motor
9
Set value for P3.1.1.1 Motor Nom Voltg
(according to nameplate)
Range: Varies
10
Set value for P3.1.1.2 Motor Nom Freq
(according to nameplate)
8.00...320.00 Hz
11
Set value for P3.1.1.3 Motor Nom Speed
(according to nameplate)
Range: 24...19.200 rpm
12
Set value for P3.1.1.4 Motor Nom Currnt
(according to nameplate)
Range: Varies
13
Set value for P3.1.1.5 Motor Cos Phi
(according to nameplate)
Range: 0.30...1.00
14
Set value
for
P3.3.1.1 Minimum frequency refer-
ence
Range:
0.00...50.00 Hz
15
Set
value
for
P3.3.1.2 MaxFreqReference Range: 0.00...320.00 Hz
16
Set
value
for
P3.4.1.2 Accel Time 1 Range: 0.1...300.0 s
17
Set
value
for
P3.4.1.3 Decel Time 1 Range: 0.1...300.0 s
18
Set value
for
P3.3.1.1 MinFreqReference Range: 0.00...50.00 Hz
19
Set
value
for
P3.3.1.2 MaxFreqReference Range: 0.00...320.00 Hz
20
Set
value
for
P3.4.1.2 Accel Time 1 Range: 0.1...300.0 s
21
Set
value
for
P3.4.1.3 Decel Time 1 Range: 0.1...300.0 s
To Next Page
Loading...
