Vacon 100 INDUSTRIAL - Page 71

User interfaces vacon • 71
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
Figure 31. Programming analogue inputs with graphical keypad
Figure 32. Programming analogue inputs with text keypad
PROGRAMMING INSTRUCTIONS
Graphical keypad Text keypad
1. Select the parameter and push the
Arrow
right
button.
1. Select the parameter and push the
OK button.
2. You are now in the
Edit mode as the slot
value
AnIN SlotA. is blinking and under-
lined.
2. You are now in the
Edit mode as the letter A is
blinking.
3. Push the
Arrow up button once to change
the slot value to
AnIN SlotC. Confirm with
OK button.
3. Push the
Arrow up button once to change the
slot value to
C. Confirm with OK button.
9264 emf