Vaisala BAROCAP PTB330 - User Port Serial Settings; Sdelay; Seri

USER'S GUIDE____________________________________________________________________
84 __________________________________________________________________ M210855EN-D
User Port Serial Settings
Use the commands described in this section to configure the user port
serial settings.
SDELAY
With the SDELAY command you can set delay (response time) for
the user port (RS232 or RS485), or view currently set delay value.
Value corresponds to tens of milliseconds (for example, 5 = 0.050s
minimum answer delay). The value can be set between 0...254.
Example:
>sdelay
Serial delay : 0 ? 10
>sdelay
Serial delay : 10 ?
SERI
Use the serial line command SERI [b p d s] to set communication
settings for the user port.
SERI [b p d s]
where:
b = Bit rate (110, 150, 300, 600, 1200, 2400, 4800, 9600,19200,
38400, 57600, 115200, 230400)
p = Parity (n = none, e = even, o = odd)
d = Data bits (7 or 8)
s = Stop bits (1 or 2)
Example:
>seri
Baud P D S : 9600 N 8 1
>
You must reset the barometer to activate the new communication
settings set with the
SERI command.